Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS (CONT.)
22. Feed the long white wire through the cutouts in all CROSSBEAMS, P8, and the Velcro on P22, toward the
back and up through the hole in the BACK BOTTOM PANEL, P12. This will connect to the short white wire on the wiring
harness.
23. Feed the Target Board's Wiring Harness through the round hole in the BACKBOARD, P13, and attach the Backboard
between the TTRIANGLE PATCH using (4) SCREWS, H1, as shown in figure 9. Note: Hand place screws in all four
pre-drilled holes to align panel before tightening.
24. Attach ELECTRONIC SCORER, P14, to Backboard using (4) SCREWS, H9, as shown. Connect the Wiring Harness
from the Electronic Scorer to the Target Board's Wiring Harness.
25. Attach COVER PANEL, P25, over Wiring Harness and to Backboard using (4) SCREWS, H11, as shown in Figure 9.
26. Plug in the AC Power Adapter (DO NOT use batteries with adapter), or install four (4) "AA" batteries (not included),
into the backside of the Electronic Scorer, P14. Remove protective plastic film from face of Electronic Scorer.
P14
H9
H11
P13
H1
P25
Figure 9
11
Publicité
