Krüger & Matz EXPLORER+ KM0553 Mode D'emploi page 15

Owner's manual
MICROSD CARD MODE
1. Insert the microSD card into the appropriate slot of the speaker.
2. The device should automatically enter microSD mode. If microSD card has been
inserted into the slot before power on, press the power button to enter microSD
card mode (mode indicator should change from blue to white).
3. Start playing music from your device.
4. During music playback, mode indicator blinks white. When music is paused,
mode indicator is on.
5. Control music playback, volume and track selection from the speaker.
CHARGING
1. Connect plug of the included AC charger to the charging socket of the speaker.
2. Connect the AC charger to power supply.
3. When the battery is charging, red charging indicator is on.
4. When the battery is fully charged, red charging indicator turns blue.
5. Disconnect the AC charger from the speaker and power source.
CHARGING EXTERNAL DEVICE
1. Make sure the speaker is turned on.
2. Connect the external device with the USB cable (not included in the set) to the
USB output of the speaker.
3. Charging should start automatically.
TWS MODE
You can connect only the speakers of the same model.
You can connect speakers only when in Bluetooth mode.
Make sure non of the speakers is connected to the external device before enabling TWS
mode.
1. Turn on speaker A and speaker B one by one.
2. Press the BT button of the speaker A twice. TWS mode indicator blinks white.
3. After successful connection between the speakers, TWS mode indicator is on.
4. Pair speaker A with external device.
5. Once paired successfully, both speakers should simultaneously play music.
6. You can disconnect the speakers by pressing and holding the BT button on either
speaker for about 3 seconds.
7. Manage all functions using buttons on either speaker.
15