Krüger & Matz EXPLORER+ KM0553 Mode D'emploi page 13

Owner's manual
OPERATION
Turn on/off
Press and hold the power button for about 2 seconds to turn on the device (mode
indicator lights up blue). The device will issue a voice prompt and automatically
enter Bluetooth pairing mode.
Press and hold the power button again to turn off the device (mode indicator goes
off).
If after pressing the power button, the device is not turning on, it may be due to low
battery. Please charge the battery and try again.
Play/ pause music
Press the play/ pause button.
Previous/ next track
Press the - button to go to previous track. Press the + button to go to next track.
Decrease/ increase volume
Press and hold the – button to decrease volume. Press and hold the + button to
increase volume.
Answer/ end/ reject call
Press the play/pause button to answer/end call. Press and hold this button to reject
call.
Note: Remain within 1 meter from the speaker's microphone for the best call quality.
PAIRING
1. Press and hold the power button for about 2 seconds to turn on the speaker. It
will automatically enter Bluetooth mode* (mode indicator blinks blue quickly).
2. Please keep the speaker and external device close to each other when pairing.
3. Enable Bluetooth function on the external device and search for new Bluetooth
devices.
4. Select and connect with this device (KM Explorer+). Enter password "0000" if
necessary.
5. The speaker will issue a voice prompt signifying a successful pairing; mode
indicator stops blinking.
6. When playing music, mode indicator blinks blue slowly. When music is paused,
mode indicator stops blinking.
* If the device will not enter Bluetooth mode automatically after power on or if you
13