Installation Of A Single Luminaire; Connecting The Device To The Power Supply - DOMUS LINE TRACK Manuel D'installation

INSTALLATION MANUAL
WARNING
Safety is guaranteed if these instructions are followed so they
must be kept. Installation may require involving qualified
personnel. Before installing the luminaire ensure that the
environmental conditions are in compliance with and suitable for
product characteristics. Before any operation on the luminaire,
disconnect the mains voltage.
INSTALLATION
The TRACK luminaires are recommended for under cabinet and
under shelf installation. Installation is possible with the luminaire
power cable axially or radially with respect to the mounting
surface. As regards special requirements, it is nonetheless possible
to install these units in other positions as long as they do not
interfere with the integrity of the wire and/or connector installed
on it.
The installation can therefore provide a SET of luminaires
connected in a continuous row with only one power cable
connected to the first luminaire that supplies power to the
luminaires connected in cascade.
The continuous line connection can not exceed the maximum load
of 72W @24Vdc.
The continuous row installation in which the TRACK controller-
TRACK controller IR switch is included must be prepared
connecting this luminaire upstream of all the lamps and
downstream of the power supply cable.
ATTENTION:
The TRACK controller- TRACK controller IR electronic switch must
be connected respecting the orientation of the connections
IN-OUT as shown in figure 4.
EN
TRACK and the TRACK controller- TRACK controller IR switch can
be installed individually or as a MASTER luminaire in a continuous
row SET. For a correct operation, it is not possible to connect
multiple TRACK controllers in a continuous row. Furthermore, it is
not allowed to connect the TRACK + TRACK controller- TRACK
controller IR to a power supply connected to a socket controlled
by a switch or downstream of other electronic controllers or
dimmer.

INSTALLATION OF A SINGLE LUMINAIRE

- Fix the clips (A) to the installation surface using the screws (B)
supplied in the package as shown in figure 1.
- Connect the power supply cable (D) to the TRACK controller-
TRACK controller IR or to the input connector (C) of the TRACK
then attach the profile to the clips (A) fixed to the installation
surface.
INSTALLATION OF LUMINAIRES IN CONTINUOUS ROW
- Fix the clips (A) to the installation surface using the screws (B)
supplied in the package as shown in figure 1.
- Connect the power supply cable (D) to the TRACK controller-
TRACK controller IR or directly to the power supply connector (C)
of the lighting profile.
- If necessary, use the appropriate extension cables (F) or
interconnection connectors (G) for continuous row
- Finally, attach the profile to the clips (A) fixed to the installation
surface.

CONNECTING THE DEVICE TO THE POWER SUPPLY

Connect TRACK only to a safe power supply with 24Vdc stabilised
voltage (sold separately) and with power at least 10% higher than