Publicité
Les langues disponibles
Les langues disponibles
WELL™ Flex QRG
DMX Linking
DMX Connection
Master/Slave
Connection
Wireless
Operation
Initial Setup
Configuration
Product Pairing
Storage Notes
The WELL™ Flex will work with a DMX controller using a 5-pin DMX serial
connection. A DMX Primer is available from www.chauvetprofessional.com.
The WELL™ Flex uses a 5-pin DMX data connection for its DMX personalities:
4 Ch, 6 Ch, 10Ch, HSI and HSV. See the User Manual for information about
connecting and configuring the product for DMX operation.
The WELL™ Flex uses the DMX data connection for its Master/Slave mode. See
the User Manual for information about connecting and configuring the product for
master/slave operation.
Master/Slave mode not available in wireless operation.
The WELL™ Flex can operate in W-DMX™ mode up to 300 m (900 ft) from the
W-DMX™ transmitter. The W-DMX™ receiver in the WELL™ Flex must be
paired with the W-DMX™ transmitter for wireless operation.
1.
Turn the W-DMX™ transmitter on.
2. Connect the W-DMX™ transmitter to a DMX controller.
3. Place the WELL™ Flex within 300 m from the W-DMX™ transmitter.
4. Disconnect any DMX cable from the WELL™ Flex.
5. Turn the WELL™ Flex on.
1.
From the WELL™ Flex's control panel, go to DMX Address.
2. Select the start address, as with any other DMX compatible product.
3. Go to Wireless Setting > Receive.
4. Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5. Press the reset button on the W-DMX™ transmitter.
(The Signal Strength Indicator on the WELL™ Flex will show a
ϟ in front of the bars for 3 seconds while a connection is established.)
If the WELL™ Flex has already been paired with the W-DMX™ transmitter, the
Signal Strength Indicator in the middle of the LCD screen will show the strength
of the signal. In this case, the WELL™ Flex is ready to work in Wireless mode.
Pairing the WELL™ Flex and a new W-DMX™ transmitter
1.
From the WELL™ Flex's control panel, go to Wireless Setting.
2. Select Reset. The Signal Strength Indicator on the WELL™ Flex will show a
? in front of the bars.
3. From the W-DMX™ transmitter, press <RESET> (the Signal Indicator on the
transmitter will flash).
4. Once the transmitter has found the WELL™ Flex, the Signal indicator on the
W-DMX™ transmitter will illuminate solid.
5. The Signal Strength Indicator in the middle of the LCD screen on the
WELL™ Flex will show the strength of the signal.
·
Always store the product in an upright position (≤ 10° tilt).
·
Recharge the battery to full capacity before storing the product.
·
Store charged product(s) in a dry environment, away from direct sunlight.
W-DMX™ operation can be interrupted or inhibited by liquid masses
between the transmitter and receiver such as water, snow, or people. For best
results, keep the area between the transmitter and receiver clear of any liquid
mass.
4
EN
Publicité
