Publicité
Les langues disponibles
Les langues disponibles
WELL™ Flex QRG
AC Power
AC Plug
Battery Charge
Notes
Replacing the
Fuse
This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
Connection
AC Live
AC Neutral
AC Ground
·
Recharge the battery within three days from last use.
·
Recharge the battery to full capacity before storing this product.
·
For best results, charge the battery in a temperature between 32 °F (0 °C)
and 95 °F (35 °C).
·
When charging the battery, keep the product at no less than 1 m from any
open flame or hot plate.
·
When charging the battery inside the road case charger, keep the road
case's cover open.
·
Always charge the battery with the product in an upright position.
·
Do not charge the battery for more than 24 hours.
·
Perform a full discharge/recharge cycle every three months.
Be sure to remove rubber plug from the bottom of the product before
charging in the road case.
The WELL™ Flex has no external fuse. However, the road case charger comes
with a replaceable fuse.
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the
housing.
3. Remove blown fuse and replace with a good fuse of the same type and
rating.
4. Screw the fuse holder cap back in place and reconnect power.
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
3
Screw Color
Brown
Yellow/Brass
Blue
Silver
Green
EN
Publicité
