VINCENT RC-572 Manuel D'utilisation page 73

1. On the HOME page select
MENU, then LEARN, followed by
LEARN DEVICE KEY. Now press
the device key to which the func-
tion key to be programmed
belongs and select the desired
function key.
2. The display now reads
"Learning" and both remote con-
trols should oppose each other.
Hold down the original remote
control key until the display reads
"Learn OK!". If the signal is recei-
ved erroneous, the display shows
the text "LEARN ERROR" and the
old infrared function (if any) of
the function key will be kept. If no
signal is received, the display
reads "NO DATA" and the old
infrared function (if any) of the
function key will be kept. Check
in both cases if the batteries of
the original remote control are
used up and if both controls are
positioned face-to-face while lear-
ning.
3. After a learning trial other func-
tion keys can be programmed in
the same way, just touch the desi-
red key.
Vincent
73