Measure The Tow Vehicle; Installation And Setup - Husky 32215 Instructions D'assemblage, D'installation, De Fonctionnement Et D'entretien

Measure the Tow Vehicle

For vehicles with air springs, air shocks or automatic leveling systems only: Check vehicle owners
manual or other instructions on these items. Unless otherwise indicated, air springs and air shocks
should be deflated to their minimum recommended pressure BEFORE assembling and adjusting the
weight distribution hitch. Pick reference points at the top center of the front and rear fender well of
towing vehicle. Measure and record the height to pavement here:
FRONT FENDER TO PAVEMENT:
REAR FENDER TO PAVEMENT:
ILLUSTRATION 3

Installation and Setup

NOTE: To obtain proper ball height on low ground clearance tow vehicles, shank may be oriented in the
"UP POSTION" as shown in Illustration 4. If shank is used in the "DOWN POSITION, check shank for
adequate ground clearance. Accessory shanks with greater height and length are available from your
dealer. IMPORTANT! Proper adjustment requires the use of the proper length shank; proper head
height and proper head tilt adjustment.
ILLUSTRATION 4
Up (Upright)
Down (Inverted)
Position
Position
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. April 06, 2017
See www.huskytow.com for Warranty Information/Tech Support. © (2017) DTS. Mfg.
6
Page