Spring Bar Loading On Lift Brackets - Husky 32215 Instructions D'assemblage, D'installation, De Fonctionnement Et D'entretien

Spring bar loading on lift brackets

22. To load the spring bar onto the lift bracket, orient the lift tool as shown below and come under the
spring bar. Then, put the "finger" of the lift tool into the square hole on the lift bracket and using
BOTH hands on the lift tool lift up firmly and the rotate and push the lift tool towards the trailer until
the spring bar is resting completely on the lift bracket and off of the 2 pins. If it is too difficult to lift the
spring bar, then raise the height of the trailer until the spring bar is closer or vertically to the spring bar
support surface of the lift bracket.
(Rearward View)
Spring bar support surface
Lift tool finger
(Top View)
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. April 06, 2017
See www.huskytow.com for Warranty Information/Tech Support. © (2017) DTS. Mfg.
16
Page