Check All Trailer To Towing Vehicle Connections For Security And Operation; Warnings - Husky 32215 Instructions D'assemblage, D'installation, De Fonctionnement Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 The 3/4" trunnion hex bolts come lubricated from the factory re-lubricate if needed with
bearing/axle grease. Do not apply lubrication to the friction surfaces of the top and bottom plates
or on the top or bottom trunnion surfaces as this will reduce the built in friction sway feature.
After 500 miles:
 Inspect all hardware for severe wear, replace and/or torque to factory specifications when needed.
 Check the tightness of the 3/4" trunnion hex bolts with a torque wrench. The torque is 150 ft. lbs.
 Inspect hitch ball for severe wear and ensure the hitch ball nut is torqued properly.
 Check to see that all shank bolts are properly tightened (380 ft. lbs.)
 Inspect spring bars for severe wear and there is no noticeable damage.
 If in doubt as to whether or not wear is beyond a safe limit always call the Husky Tow Technical
support line and discuss with a trained technical advisor.

Check All Trailer to Towing Vehicle Connections for Security and Operation

NOTE: Surge brakes usually require a small amount of fore and aft movement for their actuating
mechanism to function. Tighten the two ¾" bolts to 380 ft. lbs. torque once the head angle is set. Those
surge brake actuators not designed for use with a weight distributing hitch may bind and not operate
freely. Check your surge brake operating instructions for any specific requirements regarding their use
with weight distributing hitches.

Warnings

Loaded ball height should never be greater than what these instructions allow! Front wheel overload and
loss of rear wheel traction can result and can lead to unstable handling. It can reduce braking ability and
create a tendency to "jackknife" when turning and braking at the same time.
Loss of steering may result in a "high nose" trailer setup. If this occurs refer to page 10 "CHECK
VEHICLE HEIGHT AND ADJUST SPRING BARS IF NECESSARY" and make the necessary equipment
adjustment or tow vehicle and/or trailer load adjustments.
Short wheel base vehicles may induce sway when towing a trailer. USE EXTREME CAUTION.
Caution:
FRONT WHEEL DRIVE VEHICLES:
Do not attempt to hook-up or tow with the rear tires of the towing vehicle removed. Severe structural
damage to the towing vehicle, hitch and trailer may result. A towing vehicle/trailer combination cannot be
controlled adequately unless the towing vehicle's rear wheels are carrying their share of the load.
CAUTION!
Using the Bolt Together Weight Distribution System without the spring bars removes all weight
distribution functionality of the product.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. April 06, 2017
See
www.huskytow.com
for Warranty Information/Tech Support. © (2017) DTS. Mfg.
25
Page

Publicité

Table des Matières
loading

Table des Matières