flamco Logotherm LogoTronic Instructions D'utilisation page 6

2. Description
2.1 Technical data
Model
Power supply
Power consumption
Internal fuse
Theory of operation
Degree of contamination
Overvoltage category
Permissible ambient conditions
in operation
in transport/storage
Housing
Dimensions
Display
Operation
2.2 About the controller
The LogoTronic HIU controller V2 was developed to control heat interface units (HIU) in heating
networks. The controller is not a finished product but is instead supplied installed and prewired
as a component of a heat interface unit.
The controller is designed solely for installation in a finished product (heater) and is supplied
solely to manufacturers of heating products.
If the controller is installed outside the heating equipment, corresponding tensile loads on the
cables must be taken into account.
6
LogoTronic HIU Controller für LogoMatic G2
LogoTronic HIU controller V2
200 – 240VAC, 50 – 60Hz
5W (power adapter with electronics) +
external consumers (pumps, valves)
2A delay
Type I
II
II
0 °C – 40 °C, maximum 85% relative air humidity
at 25 °C
0 °C – 70 °C, no condensation permitted
3-part, plastic polycarbonate / ABS
250 mm x 175 mm x 48 mm
5 LED
2 keys for service personnel and controlled
by app