LENCO SCD-6900 Mode D'emploi page 11

Bluetooth connecting and playback
1. Press the Function button (9) to select "BT / AUX" mode.
2. If the Aux‐in jack is not connected, the system will switch to BT mode automatically and "BT "with the
flashing of "Pairing" will be shown on the LCD display (8). It means the Bluetooth is in searching
mode.
3. Switch on theBluetooth feature of your Bluetooth device (such as mobile phone) and select "Lenco
SCD‐690" Bluetooth equipment to connect.
4. Once connected successfully, the LCD display (8) will show "BT Connected ".
Start playback from your Bluetooth device and enjoy the music.
5. Adjust the Volume Up/Down button (14) to desired volume level.
6. To disconnect the Bluetooth connection, turn off the Bluetooth feature of your Bluetooth device. The
LCD display will show "BT "with the flashing of "Pairing" for pairing of a new device or switch off the
unit.
Listening to tape
General operation
Stop/eject key press to stop all deck operation. Press again to open the cassette door.
Fast forward key & press to start rapid tape winding in either forward or reverse direction. Press
Fast rewind key stop/eject key, the cassette spools stop turning.
Play key press to start playing tape.
Pause key press to stop tape operation temporarily. Press again to resume play.
Playback
 Select "Tape" by Function button (9)
 Put in the cassette tape.
 Press play key to active playback
 Adjust the Volume up/down control (14) to the desired level.
 Use pause key when you want to stop playback temporarily.
 Press stop/eject key
More features
A. Alarm clock setting
This function allows the system to turn on automatically and wake you up to CD, FM/DAB, buzzer or USB
mode. Set the system to standby mode, then press and hold the "Timer" key to enter the Timer setting
mode, LCD will show Timer On time, Moreover, the timer clock will flash the hour digit, this means the
unit is all ready to enter timer setting mode.
1) On time setting
2) Off time setting
3) Mode
when finished.
: Press the skip up
Timer button (13) to store the timer starting hour, minute digit will flash, press
skip up or down
(13) to store the timer on time
: After above step, the LCD will show "Timer Off" and hour digit was flashing.
Press skip up or down
button (13) to store the timer off hour, minute digit will flash, press skip up
or down (19/11) to set the minute. Then press Timer button (13) to
store the timer off time
: Then press skip up
press Timer button (13) to store the timer on mode. Press skip up
down (15/21) to select timer on volume level and press Timer button
(13) to complete the timer setting. The Unit will return to standby mode and
the display will show the timer icon " ".
or down (19/11) to set the hour. Then press
(19/11) to set the minute. Then press Timer button
(19/11) to set the hour. Then press Timer
or down (19/11) to select timer on mode. Then
11
or