Publicité
Les langues disponibles
Les langues disponibles
Mounting and securing
Mark out and drill fixing holes for door closer and guide rail using fitting template or cut M5 thread
X
if necessary.
Drill additional hole (A) for 24V DC power supply.
X
In case this product is in use with an hold-open device, please observe the document "Instructions for
Installation, Commissioning, Operation and Maintenance of the GEZE Hold-Open Device FA GC" as well.
6.2
Mount guide rail and end caps
The cable connection must point to the pull side.
Align spacers on guide rail (
X
Fix guide rail in place (tightening torque: 2 Nm) (
X
Align end caps and screw it on (
X
Mount door closer according to instructions (
X
All screwing torques are to be adjusted on site, if necessary.
6.3
Mount sliding lever and connect with sliding block
Connect sliding lever with door closer (tightening torque 14 Nm) (
X
Connect sliding lever to sliding block. Tightening torque: 5 Nm (
X
GB 4
1.).
2.).
3.).
4.).
1.).
2.).
TS 5000 E
Fig.: 6.2.1
Fig.: 6.3.1
Publicité
