Publicité
Les langues disponibles
Les langues disponibles
Note: Before the press of this button,please put enough ice into the shaved ice bowl and cover
the bowl cap well.
Step 8.
to increase the ice making time,and press
Press
ice making time,thickness of ice will be different
Step 9.
Press
button to stop the machine.
Step 10.
Pull the unit a little forward and put a tank below the unit, then pull the drain plug at middle of the tank to
drain water.
Step 11.
If you want to take off the pipe,sketch as below,firstly take off the blue ring named as A(if any),then press
the white ring(lock) at the outer side named as B,At last take out the pipe
Caring
1.Clean the water tank, ice basket and evaporator frequently. When cleaning, unplug the unit and
remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside
surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids,
gasoline or oil. Rinse thoroughly before starting.
2.Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
3.To ensure the cleanliness of the ice cubes, water in the water reservoir is suggested to be replaced
every 24 hours.
4.If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do not
start the system right away, wait 3 minutes, and then re-start the Ice maker.
5.Always use fresh water before starting ice production either at initial installation or after a long shut-off
period.
6.This unit is for home use only,not for outdoor use,if it is necessary for use outside,please make sure
the view window is closed.
Safety Notice
In order to avoid any accidents, please refer to following operation:
1. Disconnect power before servicing.
2. Do not pull directly on wire when plugging or unplugging the unit.
3. If ice is abnormal, please call the seller.
4. It is normal for the compressor and condenser surface to reach temperatures between 70° C and 90° C
to decrease the time.Different
Publicité
