Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease
filters before operating hood.
Exterior Surfaces
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid watermarks.
Cleaning Method:
Liquid detergent soap and water or all-purpose cleanser
■
Wipe with damp soft cloth or nonabrasive sponge,
■
and then rinse with clean water and wipe dry.
Metal Grease Filter
1. Open the stainless steel panel. Grasp panel at the left
corners and pull down to disengage the 2 catch pins from
the spring catches. The panel is attached at the right and
will rotate down.
2. Remove the filter by pulling the spring-release handle
and then pulling down the filter.
A
A. Spring-release handle
3. Wash metal filter as needed in dishwasher or hot
detergent solution.
4. Reinstall the filter by making sure the spring-release handles
are toward the front. Insert aluminum filter into upper track.
5. Push in spring-release handle.
6. Push up on metal filter and release handle to latch into place.
14
RANGE HOOD CARE
Cleaning
Non-Vented (recirculating) Installation Filters
The charcoal filter is not washable. It should last up to
6 months with normal use. Replace with Charcoal Filter
Kit Number W10412939.
To replace charcoal filter:
1. Remove metal grease filter from range hood.
2. Bend spring clips away from metal grease filter.
3. Place charcoal filter into top side of metal filter.
4. Bend spring clips back into place to secure the
5. Replace metal grease filter. See "Metal Grease Filter"
Replacing a LED Lamp
The LED lights are replaceable by a service technician only. See
"Assistance and Service" section for service contact information.
See "Metal Grease Filter" in this section.
charcoal filter to the metal filter.
in this section.
Publicité
Table des Matières
