Publicité
Les langues disponibles
Les langues disponibles
2. While holding the screwdriver, remove the flange nut
by turning it counterclockwise with a 13 mm wrench
(not supplied) as shown in Fig. D.
3. Remove the blade spacer
shown in Fig. D. Examine all pieces for damage and
replace if necessary.
Installing the New Cutting Blade
1. Install new blade
4
on shoulder of the blade cutter shaft
bushing
18
as shown in Fig. D.
2. Align the shaft bushing hole
slot
20
and insert a screwdriver into the bushing hole.
3. Hold the screwdriver in position.
4. Install the blade spacer
22
wide flat side faces the blade.
5. Install flange nut
21
with the flange against the blade
spacer
22
and securely tighten with a 13 mm wrench
(not supplied).
6. Tighten nut counterclockwise against the blade while
holding the locking rod:
‑
If using a torque wrench and an 13 mm socket
tighten to: 325 ‑335 in lb, 27 ‑ 28 ft. lb, 37 ‑ 38 Nm.
‑
Without a torque wrench, use a 13 mm closed‑end
or socket wrench, turning the nut until the blade
retainer is snug against the shaft bushing. Ensure that
the blade is installed correctly, then rotate the nut an
additional 1/4 to 1/2 turn counterclockwise.
7. Remove the screwdriver from the locking rod slot
Repairs
The charger and battery pack are not serviceable. There are
no serviceable parts inside the charger or battery pack.
WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a D
WALT factory service center or a
e
D
WALT authorized service center. Always use identical
e
replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
• Register online at www.dewalt.com
21
22
and the blade
4
as
with the locking rod
19
on the blade so that the
20
.
Three Year Limited Warranty
D
WALT will repair or replace, without charge, any defects
e
due to faulty materials or workmanship for three years
from the date of purchase (two years for batteries). This
warranty does not cover part failure due to normal wear
or tool abuse. For further detail of warranty coverage and
warranty repair information, visit www.dewalt.com or call
1‑800‑4‑D
WALT (1‑800‑433‑9258). This warranty does
e
not apply to accessories or damage caused where repairs
have been made or attempted by others. THIS LIMITED
WARRANTY IS GIVEN IN LIEU OF ALL OTHERS, INCLUDING
THE IMPLIED WARRANTY OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, AND EXCLUDES ALL
INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do
not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential
damages, so these limitations may not apply to you. This
warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty D
1 YEAR FREE sERViCE
D
WALT will maintain the tool and replace worn parts caused
e
by normal use, for free, any time during the first two years
after purchase.
2 YEARs FREE sERViCE On D
DC9071, DC9091, DC9096, DC9182, DC9280, DC9360,
DCB120, DCB122, DCB124, DCB127, DCB201, DCB203BT,
DCB207, DCB361
3 YEARs FREE sERViCE On D
DCB200, DCB203, DCB204, DCB204BT, DCB205, DCB205BT,
DCB206, DCB208, DCB230, DCB240, DCB606, DCB609,
DCB612, DCB615
nOTE: Battery warranty voided if the battery pack is
tampered with in any way. D
injury caused by tampering and may prosecute warranty
fraud to the fullest extent permitted by law.
90 DAY MOnEY BACK gUARAnTEE
If you are not completely satisfied with the performance of
your D
WALT Power Tool or Nailer for any reason, you can
e
return it within 90 days from the date of purchase with a
receipt for a full refund – no questions asked.
lATin AMERiCA: This warranty does not apply to products
sold in Latin America. For products sold in Latin America,
see country specific warranty information contained in
the packaging, call the local company or see website for
warranty information.
FREE WARning lABEl REPlACEMEnT: If your warning
labels become illegible or are missing, call 1‑800‑4‑D
(1‑800‑433‑9258) for a free replacement.
English
WALT tools are covered by our:
e
WAlT BATTERY PACKs
e
WAlT BATTERY PACKs
e
WALT is not responsible for any
e
WALT
e
9
Publicité
