Kenmore Elite 253.17202 Guide D'utilisation Et D'entretien page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before You Call
CONCERN
Appliance runs too
much or too long.
Interior temperature
is too cold.
Interior temperature
is too warm.
External surface tem-
perature is warm.
SOUND AND NOISE
Louder sound levels
whenever appliance
is on.
Longer sound levels
when compressor
comes on.
Popping or cracking
sound when com-
pressor comes on.
Bubbling or
gurgling sound, like
water boiling.
POTENTIAL CAUSE
• Room or outside
weather is hot.
• Appliance has recently
been disconnected for
a period of time.
• Large amounts of warm
or hot food have been
stored recently.
• Door is opened too
frequently or too long.
• Door may be
slightly open.
• Temperature Control is
set too low.
• Gasket is dirty, worn,
cracked, or poorly fitted.
• Temperature Control is
set too low.
• Temperature Control is
set too warm.
• Door is kept open too
long or is opened
too frequently.
• Door may not be
seating properly.
• Large amounts of warm
or hot food may have
been stored recently.
• Appliance has recently
been disconnected for
a period of time.
• The external walls
can be as much as
30°F warmer than
room temperature.
• Modern appliances
have increased storage
capacity and more
stable temperatures.
They require a high
efficiency compressor.
• Appliance operates at
higher pressures during
the start of the ON cycle.
• Metal parts undergo
expansion and
contraction, as in hot
water pipes.
• Refrigerant (used to
cool appliance) is
circulating throughout
the system.
COMMON SOLUTION
• It's normal for the appliance to work harder
under these conditions.
• It takes 24 hours for the appliance to cool
down completely.
• Warm food will cause appliance to run more
until the desired temperature is reached.
• Warm air entering the appliance causes it to
run more. Open doors less often.
• See "DOOR PROBLEMS" in Before You
Call .
• Turn control knob to a warmer setting. Allow
several hours for the temperature to stabilize.
• Clean or change gasket (See "Care and
Cleaning Tips"). Worn, cracked or poorly
fitting gaskets should be replaced.
• Turn the control to a warmer setting. Allow
several hours for the temperature to stabilize.
• Turn control to a colder setting. Allow several
hours for the temperature to stabilize.
• Warm air enters the appliance every time the
door is opened. Open the door less often.
• See "DOOR PROBLEMS" in Before You Call.
• Wait until the appliance has had a chance to
reach its selected temperature.
• Appliance requires 24 hours to cool
down completely.
• This is normal while the compressor works to
transfer heat from inside the cabinet.
• This is normal. When the surrounding noise
level is low, you might hear the compressor
running while it cools the interior.
• This is normal. Sound will level off or
disappear as appliance continues to run.
• This is normal. Sound will level off or
disappear as appliance continues to run.
• This is normal.
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Elite 17802Elite 27002Elite 27003Elite 27009Elite 27702

Table des Matières