Renfert 2300-0001 Mode D'emploi page 9

ENGLISH
1. Introduction
We are pleased with your decision to purchase the
Catalyser.
Please read the following operating in-
structions carefully and observe the safety
information they contain in order to ensure
a long and trouble-free service life.
2. Area of Application
The catalyst converter is intended to reduce odours
which are the result of heating investments and
burning waxes in the Magma preheating oven. As
a collateral action, this chemical process leads to a
reduction of toxic substances.
Depending on the particular materials being
processed, hazardous substances may still
be generated even when the catalyst con-
verter is used.
In such cases, additional measures to remove the
flue gases must be implemented. Local ordinances
and requirements must be complied with.
2.1 Ambient Conditions
(in accord. with DIN EN 61010-1)
The unit may only be used:
• Indoors;
• Up to an altitude of 2,000 m above sea level;
• At an ambient temperature range between
5 - 40 ºC [41 - 104 ºF] *);
• At a maximum relative humidity of 80 % at 31 ºC
[87.8 ºF], dropping in a linear manner to 50 %
relative humidity at 40 ºC [104 ºF] *);
• With mains power where the voltage fluctuations
do not exceed 10 % of the nominal value;
• Under contamination level 2 conditions;
• Under over-voltage category II conditions.
*) Between 5 – 30 °C [41 – 86 °F], the unit can be operated at
a relative humidity of up to 80 %. At temperatures between
31 – 40 °C [87.8 – 104 °F], the humidity must decrease
proportionally in order to ensure operational readiness (e.g.,
at 35 °C [95 °F] = 65 % humidity; at 40 °C [104 °F] = 50 %
humidity). The unit may not be operated at temperatures above
40 °C [104 °F].
Catalyser
2300-0001 / 2300-3001
3. Hazard Information
3.1 Symbology
The following symbols are employed in these instruc-
tions and on the unit itself:
- 1 -
Danger
This indicates a direct risk of injury.
Electrical current
This indicates a hazard due to electrical
current.
Attention
Failure to observe the associated informati-
on can result in damage to the unit.
Note
This provides the operator with useful infor-
mation to make working with the unit easier.
Only intended for indoor use.
Before opening the unit, disconnect it from
the mains power supply by unplugging the
power cord from the wall outlet.
Note the operating instructions.
EN