Haier AS09SH1ERA Manuel page 11

Operation
FRESH Operation
Exhaust the vitiated air from the room, and inhale fresh air.
(This function is unavailable on some models.)
Press FRESH button "
displayed on the remote controller and
AM
" " is displayed on the display board,
and the change-for-fresh-air
SMART
operation begins.
For twice press , the display "
disappears and the change-for-fresh-
air function operation is canceled.
Note：
If the unit didn't install change-for-fresh-air electrical
engine, change-for-fresh-air function is not available.
About change-for-fresh-air function
After the change-for-fresh-air function is initiated,
the outside air can enter the indoors through the
change-fresh-air tube thereby keeping the indoor
air fresh.
Setting the change-for-fresh-air function under
the shutdown status, press the fresh air key and
the remote controller displays the on status of air
flow, low wind,and change-for-fresh-air functions,
and now can set the timing open, timing close
and time control switch.
The dual fresh air has a memory function, which
can be cancelled by pressing the key one time.
Under the smart mode, after the machine has
been running for a while,the dual fresh air
function will be started automatically,it will be
automatically stopped after continuously running
for a while.
Emergency operation and test operation
Emergency Operation:
Use this operation only when the remote
controller is defective or lost.
When the emergency operation switch
is pressed,the"Pi" sound is heard once,
which means the start of this operation.
In this operation,the system automatically selects the
operation modes,cooling tor fan or heat, according to
" is
the room temperature.
Room
temperature
ABOVE 23
BELOW 23 C
function
(cooling only uint)
Room
temperature
BELOW 23
It is not possible to operate in dry mode.
Test operation:
"
Test operation switch is the same as
emergency switch.
Use this switch in the test operation when
the room
not use it in the normal operation.
Continue to press the test operation switch for more than
5 seconds. After you hear the
your finger from the switch:the cooling operation starts
with the air flow speed
For smart Use of The Air Conditioner
Air Filter cleaning
Open the inlet grille by pulling
it upward
Remove the filter
Push up the filter's center tab slightly until it is
released from the stopper, and remove the filter
downward.
Clean the filter
Use a vacuum cleaner to remove dust, or wash
the filter with water. After washing, dry the filter
completely in the shade.
Attach the filter
Attach the filter correctly so that the
"FRONT" indication is facing to the
front. Make sure that the filter is
completely fixed behind the stopper.
If the right and left filters are not
attached correctly, that may cause defects.
Close the inlet grille
Operation
Designated
mode
temperature
O C COOLING 26 O C
O O C
HEAT 23
Designated
Operation
mode temperature
O
C FAN 26 O C
o
temperature is below 16 C, do
"Pi" sound twice,release
"Hi".
Pi
Timer
Air flow
mode
NO AUTOMATIC
NO AUTOMATIC
Timer
Air flow
mode
AUTOMATIC
NO
Pi Pi
Once every
two weeks
9