Operation - Nordcap RC200 Mode D'emploi

S a t t r n i g U p
GB Plug in the cabinet.
The display shows the actual cabinet temperature
Servicing
Make sure the appliance is switched off at the mains before service is performed on electrical parts.

Operation

Storing food
To get the best results from your appliance, follow these instructions:
• Only store foodstuffs in the appliance when it has reached the correct operating temperature.
• Always close the door, when not in use and appliance is switched on.
• Do not place uncovered hot food or liquid inside the appliance.
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance. (Refrigerator)
• Avoid opening the door for prolonged periods of time.
• The maximum load for a shelf is 25 kg.
• The food must be put into container before placed into cabinet or on the shelf. Food must not be placed into food cabinet directly.
Turn on
• Close the door of the appliance.
• Ensure the power switch is set to [O] and insert plug into socket.
• Switch on the Power [I]. The current temperature within the appliance is displayed.
• The on the display will flash for 3-min to indicate a delay between the motor compressor being stopped and then restarted.
Temperature setting and control
Thermostat display and control panel
1. Defrosting light
2. Compressor operation light
3. Digital thermostat
4. Programming key (Service agent only)
5. Temperature modifi cation keys
6. Manual defrost
How to see the set point
• Push and immediately release the SET key, the set point will be showed;
• Push and immediately release the SET key again or wait about 5s to return to normal visualisation.
How to change the set point
• Push the SET key for more than 2 seconds to change the set point value;
• The value of the set point will be displayed and the "°C" starts blinking;
• To change the set value push the „
• To memorise the new set point value push the SET key again or wait 10s.
Main switch
Lock
1 2
6
SET
4
" (up) or „ " (down) arrows within 10s.
Thermostat Display
5
3
6