Publicité
a ventilated environment. After cleaning, the mechanism can be lubricated. Cleaning and lubrication are
present, as listed in the following paragraph.
CHECKING AND MAINTENANCE - CARABINERS
A carabiner looses half of its resistance when the gate is open (see Tab.K): check the correct operation the lever prior
to use: The lever must return against the connector body when closed, the automatic locking device must close fully
with about external help. Mud, sand, pain, ice, dirty water and other agents can compromise the operation. Do not
use connectors with defective operation. If an operational defect appears, clean and lubricate the mechanism with a
silicon based lubricant. Clean and lubricate are recommended after each use in marine environments. If, after oiling,
the defect persists, the carabiner has to be put out of use
REVISION
inspection required before, during and after each use, this product must be inspected by a skilled person every 12
: keep this literature for inspection and reference for the life of the device. Check the legibility of
In case of one of the following defects are present, the product should be withdrawn from
service immediately:
Textile elements:
• cuts and/or burns on the webbings/ropes
• cuts and/or burns on the stitching
• partial or total extension of the energy absorber with break of the fall indicator.
Tangle-free swivel device (Gyro) and connectors:
•
to be greater than 1 mm;
• creation of excessive play between the elements;
• presence of cracks;
• corrosion that seriously alters the surface state of the metal (it does not disappear after a slight rubbing with
sandpaper);
• presence of permanent deformations;
• operative problems that cannot be resolved through cleaning or lubrication.
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service immediately.
Each product in the safety system can be damaged during a fall and must be always inspected before use it again.
are visible.
LIFETIME
The lifetime is understood to be in the absence of causes which would place the product out of order with the
condition that periodic inspections are carried out at least once every 12 months starting from the date the product
lifetime of the product: intense use, damage to components of the product, contact with chemical substances, high
temperatures, tears and abrasions, violent impacts, failure to maintain as recommended. If a product is suspected
to be no longer safe and reliable, replace the product or contact C.A.M.P. or the distributor before continuing use.
Retexo:
consideration) in any case cannot exceed the end of the twelfth year from manufacturing (i.e. manufacture year 2020,
41
Publicité
