Publicité
but rather EN 795:2012 Type C or D anchors.if the edge is sharp or has a radius less than 0.5mm you must
avoid any and all possibility of a fall over and provide a cover for such edge; contact the manufacturer for
any information needed;
• the device anchor point must always be above or at the same level as the workspace (
•
•
• avoid slack;
• for the calculation of clearance, use the same data provided in
•
event of fall must be taken into account when calculating the required clearance distance. Read the instructions
for use of the lifeline;
•
Rescue
Provide adequate rescue equipment and allow for adequate worker crew training, so that they can act quickly in the
case of a fall, in particular during horizontal work.
EAC use
is marked on the label of the product.
INSTRUCTIONS FOR USE – CARABINERS
Summary
suitable for use in fall arrest systems for protecting against the risk of falling from heights. Some models are even
connectors are highlighted in Tab. K, identifying the reference code(s) on the marking of the connector(s) supplied
with the product.
Classes (Tab. K)
T: directional connector. Class Q: quick link. Class M: multiple use connectors.
oval connector. Class Q: quick link. The main material that the connector is made from is indicated in Tab. K in the
"Material" column: S = Steel, SS = Stainless Steel, AL = Aluminum alloy.
Use
the fall height. The connection of the connector is indicated in the tab.K
with manual locking (
used for connections that are not opened often, we recommend closing with a torque of 3 Nm for quick links with a
diameter of 8 mm and 7 Nm for those with the 10-12 mm diameter, partial closure of the nut must always be avoided
(
). For proper use and for connection to a reliable anchoring point with only one sub-system and to other
components in a fall protection system, see
K7-K8). Avoid positions that can stress the connector lever (
lever, choose to use ANSI Z359.12 connectors that have greater lever strength (
CHECKING AND MAINTENANCE – RETEXO
Check the correct function of the movable parts of the connectors and of the tangle-free swivel device [8] at each
use. In case of dirt, clean with a blast of compressed air and/or immerse in fresh water and subsequently dry in
) must avoid detaching them several times in the same working day. The quick links are
;
K1 to K6. The user of connectors
); if it is not possible to avoid stress on the
40
);
);
tab.A and the standard number
).
Publicité
