Safety Recommendations - SKF TIH 030m Mode D'emploi

• Because the TIH 030m generates a magnetic field, people wearing
a pacemaker must not be within 5 m (16 ft) of the TIH 030m during
operation. Electronic equipment, such as wristwatches, may also
be affected.
• During the heating process observe a safety distance of 50 cm (1.6 ft) with
the workpiece, the heater coil or the core.
• Follow the operating instructions at all times.
• Be certain that the voltage supply is correct.
• Electrical arcing may occur when a potential difference exists between the
TIH 030m and the workpiece. This is not dangerous to human beings and
will not cause damage to the TIH 030m or the workpiece. However, the
TIH 030m must never be used in areas where there is a risk of explosion.
• Do not expose the TIH 030m to high humidity.
• Never operate the TIH 030m without a yoke in position.
• Never operate the TIH 030m with the cable of the remote control between
the vertical supports of the yoke.
• Do not modify the TIH 030m.
• Use proper handling equipment when lifting heavy workpieces.
• Avoid contact with hot workpieces. Wear the supplied heat resistant gloves
to handle hot workpieces.
4

Safety recommendations

SKF TIH 030m