Operating The Appliance - Ellipse Corbeil ERTM180W Guide D'installation Et D'utilisation

5

OPERATING THE APPLIANCE

.
CONTROL /DISPLAY PANEL
The display outline applies to the following picture:
4.1 DISPLAY AND DESCRIPTION

SET button: press to change the refrigerator setting from 1 (cold) to 5 (coldest).

LED setting indicators: show the current refrigerator setting (1 to 5)

STANDBY button: indicates when the unit is in standby mode (refrigerator and freezer are turned off).

The first time you turn the refrigerator on, the setting indicators will all lit for three (3) seconds then the panel will
display the current/default setting (the default setting is = 3). Your refrigerator will run continuously for several
hours until it reaches the preset temperature. Once your refrigerator is fully cooled, you can adjust the
temperature up or down according to your personal preference.

To temporarily suspend cooling in the refrigerator and freezer, press and hold the SET button and hold for (3)
three long seconds. The STANDBY button will turn on and cooling will be turned off. Press the SET button again
to cancel standby mode and resume cooling.
4.2 SETTING INDICATORS
Each time the key "SET" is pressed, the position changes. Once the setting has been chosen, the refrigerator will operate
according to the set value after a period of five (5) seconds.
From left to right, the temperature is lowered (colder). The settings are:
4.3 THE « STANDBY » FUNCTION
When the refrigerator is on, push the SET button for three (3) long seconds and then release. The refrigerator will now go on
STANDBY mode. The STANDBY indicator light will turn on and all operations will stop.
To cancel the STANDBY mode simply press the SET button and the refrigerator will resume the normal working mode. The
STANDBY indicator light will turn off.
30