Ellipse Corbeil ERTM180W Guide D'installation Et D'utilisation page 27

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. REVERSING THE DOORS (continued)
REMOVING THE REFRIGERATOR DOOR
1.
Remove all food from the unit.
2.
Tape the door shut with masking tape.
3.
Remove the center hinge by taking out the two hinge screws using a 5/16 socket wrench. Put the center hinge and
screws aside.
4.
Remove the tape and tilt the door away from the cabinet. Lift the door straight up to release the bottom socket
from the pin of the bottom hinge bracket.
5.
Transfer plastic bushing from right top side of the refrigerator door to the left side.
6.
Set the door aside on a non-scratching surface with the inside facing up.
7.
Install the two (2) hole cover caps from the opposite side of the cabinet to the empty screw holes of the center
hinge.
TRANSFERING THE BOTTOM HINGE TO THE LEFT SIDE
1.
Using a 5/16 Socket wrench remove the two (2) screws from the bottom hinge.
2.
Move the bottom hinge pin from the right to the left side with a flat-blade screwdriver until the shoulder of
the hinge pin is touching the hinge.
3.
Move the bottom hinge from the right to the left side and tighten the 2 screws.
4.
Install the two (2) hole cover caps from the opposite side of the cabinet to the empty screw holes of the bottom
hinge.

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour Ellipse Corbeil ERTM180W

Ce manuel est également adapté pour:

Corbeil ertm180s

Table des Matières