Troubleshooting - GreenWorks GC40L00 Manuel D'instructions

TROUBLESHOOTinG

PROBLEM
The Wheelbarrow does not
run.
The Wheelbarrow runs
sluggishly.
Sometimes the
Wheelbarrow runs, but
other times it does not.
Loud clunking or grinding
noise from the gearbox.
POSSIBLE CaUSE
Battery is not secure.
Battery is not charged.
The wire is loose.
The controller is damaged.
Battery volume is low.
The battery is old and does not
accept full charge.
The conditions are too stressful
for your Wheelbarrow.
The electrical switches might be
damaged or corroded because
they were exposed to water or
moisture, or they simply wore
down from extensive use.
The motor's gears are broken.
19
SOLUTION
To secure the battery pack, make
sure the latch on bottom of the
battery pack snaps into place.
Charger the battery pack according
to the instructions included with you
model
Check all the connectors and to
see if any part is loose or not.
Replace the damaged one with
specific controller by strictly
following up the instructions.
See the battery indicator to check
the volume. Charger the battery
pack according to the instructions
included with you model
Replace the battery with a new 40
Volt GreenWorks battery
The Wheelbarrow is intended for
residential use. if slopes are too
steep or the terrain too bumpy, your
Wheelbarrow might experience a
noticeable decrease in performance.
Contact us at 1-888-909-6757 and
we'll help you diagnose and repair
the problem.
Contact us at 1-888-909-6757 and
we'll help you diagnose and repair
the problem.