Turn The Rear Handle; Operation Tips; Maintenance; Clean The Machine - GreenWorks HTF320 Manuel Opérateur

1. Release the trigger to stop the machine.
4.3

TURN THE REAR HANDLE

Figure 4.
You can use the rotating button to adjust the rear
handle to 5 different positions to cut the hedges easier.
1. Put the machine on a flat and smooth surface.
2. Pull the rotating button and turn the rear handle.
3. Release the rotating button until it locks into
position.
4.4

OPERATION TIPS

• Do not push the machine through heavy shrubbery.
This can cause the blade blockage. If the blades
blocks,
1. stop the machine.
2. remove the battery pack.
3. remove the blockage.
• Do not try to cut too large stems or twigs.
• Wear the gloves when you cut.
• Cut the new growth with a wide sweeping action so
that the stems are put directly into the blade.
• You can use a string to adjust the height of the
hedge.
1. Stretch a piece of string along the hedge at this
height.
2. Cut the hedge immediately above this string.
3. Cut the side of a hedge until it will be narrower at
the top. More of the hedge will come into view in
that way.
5

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
English
5.1

CLEAN THE MACHINE

Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
5.2

LUBRICATE THE BLADE

To increase the efficiency and life of the blades,
lubricate them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to
remove more dirt.
• Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
6

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Attach the scabbard (optional).
3. Cool the motor.
4. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
5. Remove keys or tools used for maintenance.
6. Store the machine:
• indoors and out of children.
• prevent from inclement weather.
7

TROUBLESHOOTING

Problem
The motor does
not start when
you pull the trig-
ger.
5
WARNING
NOTE
NOTE
Possible cause Solution
Make sure that
The battery pack
you tighlty install
is not installed
the battery pack
tightly.
in the machine.
The battery pack Charge the bat-
is out of power. tery pack.
EN