Bosch GMR 1 Professional Notice Originale page 11

OBJ_DOKU-17021-001.fm Page 11 Wednesday, April 22, 2009 10:48 AM
– Push the spindle lock button 9 and keep it
pressed. If required, rotate the motor spindle
by hand until it locks. (see Fig. C1)
– Loosen the tightening nut 5 with the open-
end spanner by turning in anticlockwise di-
rection 14. (see Fig. C2)
– Insert the router bit into the collet. The shank
of the router bit must be immersed at least
20 mm into the collet.
– Retighten the tightening nut by turning in
clockwise direction.
– Release the spindle lock button.
Do not tighten the tightening nut of the col-
let without a router bit inserted. Otherwise
the collet can be damaged.
Mounting the Routing Base (see figure D)
For routing, the routing base 2 must be mounted
on the motor unit 1 again.
– Open the clamping lever 10 on the motor unit
if locked.
– Bring the two double arrows on the motor
unit and the routing base 2 into alignment.
– Push the motor unit into the routing base and
turn the motor unit in clockwise direction un-
til the mark points against the
– Push the motor unit further into the routing
base.
– After mounting is completed, turn the
mark on the routing base to the
the motor unit.
– Lock the clamping lever.
After mounting, always check if the motor
unit is seated tightly in the routing base.
If required, change the pre-tension of the clamp-
ing lever 10 (see "Readjusting the Clamping Le-
ver", page 14).
Bosch Power Tools
All manuals and user guides at all-guides.com
Mounting the Base Cover Sleeve
(see figure E)
Intensive use of the trimmer will cause the rout-
ing base to become hot. In this case, a base cov-
er sleeve (accessory) can be mounted for pro-
tection of the hands.
– Remove the clamping lever 10.
– Place the base cover sleeve 15 on the routing
– Reassemble the clamping lever again in such
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one's health. Touching or
breathing-in the dusts can cause allergic reac-
tions and/or lead to respiratory infections of the
user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials containing
symbol.
asbestos may only be worked by specialists.
– Provide for good ventilation of the working
symbol on – It is recommended to wear a P2 filter-class
base 2 from above.
a manner that the motor unit 1 is held se-
curely in the routing base when the clamping
lever is locked.
place.
respirator.
Observe the relevant regulations in your
country for the materials to be worked.
2 609 140 653 | (22.4.09)
English | 11