Austroflamm Tower Xtra 2.0 Manuel D'instructions page 9

english
Heating in-between seasons
Heating the stove in between seasons, when the
outside temperatures are higher, the flue gases may
not be able to escape completely and this may lead to
disturbances in the chimney draught, especially if the
temperatures are rising suddenly. The stove has to
be charged with less wood and the primary air has to
be increased so that the wood can burn down faster
(with visible flames) and thus the chimney flue can
stabilize.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description
Flat gasket 8x2 mm (1,8 m)
Gasket round Ø 6 mm (2 x 0,5 m)
Gasket round Ø 14 mm (1,8 m)
Keramott
Description
Bottom left, Keramott
Bottom right, Keramott
Wood retainer, Keramott
Rear, Keramott
Side component left, Keramott
Side component right, Keramott
Baffle plate, Keramott
Grate
Other parts
Description
Door - cast grey
Door- nougat
Door handle
BA1 door spring
Door glass
Glass cleaner ½ litre
Stove lacquer - cast grey
Stove lacquer - nougat
Accessories
You can obtain floor plates of glass or steel and care products from your certified dealer.
IMPORTANT:
Have defective parts replaced by your certified dealer. This will guarantee that your
stove functions properly and safely.
The fireplae must not be amended.
Maintenance
To clean the glass, please use a specialized product such as Thermohit glass cleaner. Lacquered
surfaces are to be cleaned only with a cloth (may be damp). Special cleaning agents should also be used
for stainless steel surfaces.
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if
necessary more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned
regularly by the chimneysweeper. Your chimneysweeper will inform you of the necessary inspection
intervals. An expert should inspect the stove annually.
7
Chimney fire
A chimney fire may occur, due to sooting and
deposits in the chimney, if wrong or humid fuel is
used. Close all air inlets on the fireplace/chimney
immediately and call the fire brigade. Please have an
expert inspect your chimney for cracks and air-
tightness after the burning out of the chimney.
Nr.drawing Part number
13 710096
14 710696
15 718429
Nr.drawing Part number
1 714930
2 714931
3 714932
4 714933
5 714934
6 714935
7 714336
8 716408
Nr.drawing Part number
9 718883-29
9 718883-43
10 714661
11 718837
12 716801
-- 640070
-- 650002
-- 650005
Tower Xtra 2.0
Keramott numbering = installation instructions!