Stagnoli Hermes Instructions page 11

Attention!
• This manual is for qualified installers only and not for the end user. It is the installer's job
to explain to the user how the automatism works, about possible hazards related to it
and the need for periodical maintenance.
• Installation must be carried out by qualified personnel only, observing current
standards concerning automatic closing systems. More specifically, installation
conformity calls for observance of directive 89/392 and standards EN 12453 and EN
12445.
• Make absolutely certain the power is disconnected before carrying out any work on
the device.
•
The power lead must only be connected to supply lines fitted with adequate electrical
protection; a circuit breaker must also be installed to guarantee disconnection of all
the phases from the mains with a distance of at least 3.5 mm between the contacts.
• Be particularly careful when evaluating the safety devices to install and their location.
Always install an emergency stop device that will cut power off in the case of
necessity.
• Use original components only. Stagnoli is not liable for damages if any other
components are used.
• Do not work on the device if your hands or feet are damp or wet and do not leave it
outdoors exposed to the weather.
• This device must only be used for the purpose it has been expressly designed, any
other use is considered improper and therefore dangerous.
• Only qualified personnel must be allowed to service the unit, including changing the
courtesy light bulb whenever needed.
• Make sure that the gate structure is solid, well balanced and suitable to be motorised.
Also ensure there are no points of friction when the gate is moving.
Istruzioni Instructions Instructions
- 11 -