Electrical Connection - Chore-Time 56929 Manuel D'utilisation

THE DIRECT DRIVE BELT WINCH MUST:
• BE CONNECTED IN ACCORDANCE WITH THE WIRING RULES OF THE COUNTRY IN
WHICH IT IS INSTALLED
• NOT HAVE ENCLOSURES LEFT OPEN FOR EXTENDED PERIODS (EXCESS DUST WILL
VOID WARRANTY)

ELECTRICAL CONNECTION

The Direct Drive Belt Winch is designed to be operated with the Chore-Time reversing starter controls. The internal
connection diagram for single phase is shown below:
M
F R L1
L1 L2 E
MAINS
230V SUPPLY IN
ELECTRICAL CONNECTION
DOWN LIMIT
UP LIMIT
L2
Operation of the above control
panels is via a simple two position
control as shown below.
REVERSING STARTER
WALL CONTROL
E
9
UP
STOP
DOWN