Chore-Time 56929 Manuel D'utilisation page 10

CABLE ENTRY
Connect with min. 18 gauge wire using
conduit or gland to meet min IP55.
Suitable UL listed Liquid Tight Cordgrips
(glands) must be used; cable diameter 0.260"
(Minimum) to 0.545" (Maximum).
SYSTEM WIRING DIAGRAM
Controller
NO- UP
NC- E-STOP
NO-DOWN
ELECTRICAL CONNECTION
RECS-220P
WINCH
MOTOR
F R
UP
CONTACTOR
L1
SPLIT PHASE
MAINS SUPPLY
L1 L2 E
LI-115V, L2-115V
Electronic Centrifugal
Switch
DOWN
CONTACTOR
L2
10
Connect with min. 18 gauge wire
using conduit or gland to meet
minimum IP55 (If rubber grommet
is fitted, remove and discard to
allow use of cable gland).
Winch Limits
NC
NC
Pre-wired
Installer to wire