Frigidaire PROFESSIONAL Serie Instructions page 7

PREPARE THE HOOD
(NON - DUCTED HOODS ONLY)
Note: The following materials must be purchased separately for non-ducted recirculation installations.
Non - Ducted Recirculation Kit, Model 5304447635.
5" diameter duct.
1. Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Fig. 12
2. Discard discharge collar/damper supplied with the hood. Install the 5" to 6" adapter supplied with the Non-Ducted
Recirculation Kit.
3. Secure the plenum to the flue mounting bracket with (2) 3.9x6mm flat head screws (the screws are supplied with the
Non-Ducted Recirculation Kit "5304447635"). Fig. 13.
ELECTRICAL
SYSTEM
PLATE
PROTECTION
INSTALL THE HOOD
Note: at least two people will be required to mount the hood.
1. Raise the hood into its mounting position.
2. Align the rectangular opening on the back of the hood with the wall-mounting bracket. Gently lower the hood until it
securely engages the bracket. Fig. 14.
3. Level the hood with (2) 3.9x9.5mm mounting screws and secure with (2) 4.8x38mm mounting screws. Use drywall
anchors provided if wall studs or framing are not available. Fig. 14.
4. Mount the electrical system plate attaching it with (3) 3.9x9.5mm mounting screws. Fig. 15.
5. On ducted hoods, attach 6" round metal duct between the hood's blower collar and duct that leads to the outside location.
6. On non-ducted hoods, attach 5" round metal expandable duct between the 5"- 6" adapter on the hood the connector
on the plenum.
7. Tape all duct joints to make them secure and air tight.
8. Plug the power cord into the electric wall receptacle. Tuck excess cord behind the flue.
MOUNTING
SCREWS
(3.9x9.5mm)
MOUNTING
SCREWS
(4.8x38mm)
5"-6"
ADAPTER
MOUNTING
SCREWS
(4.8x38mm)
WALL
MOUNTING
BRACKET
RECTANGULAR
OPENING
FLAT HEAD
FIG.12
MOUNTING
(3.9x9.5mm)
FIG. 14
- 7 -
FLUE MOUNTING
3.9x6mm
BRACKET
SCREWS
PLENUM
PLATE OF
ELECTRICAL
SYSTEM
SCREWS
FIG.13
THE
FIG.15