Frigidaire PROFESSIONAL Serie Instructions page 6

INSTALL FLUE MOUNTING BRACKET
(DUCTED AND NON-DUCTED HOODS)
1. Assemble the flue mounting bracket, adjusting outside width as shown. See Figure 8.
2. Carefully center the mounting bracket directly over the range hood location.
3. Secure the bracket assembly to the ceiling using (2) 4.8x38mm mounting screws and drywall anchors (Fig. 9). Make sure
the bracket is pushed into the corner, tight against the wall and centered over the hood.
FLUE MOUNTING BRACKET
DRYWALL ANCHORS
3.9 x 6 mm
FLAT HEAD
BRACKET SCREWS
10-7/16"
4.8x38mm
(265.6 mm)
MOUNTING SCREWS
FIG. 8
FIG.9
PREPARE THE HOOD
Note: On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood
and decorative flues, prior to final installation.
DUCTED HOODS ONLY
1. Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Fig. 10.
2. Install the discharge collar into the duct connector of the range hood. Fig. 11.
DISCHARGE
ELECTRICAL
COLLAR
SYSTEM
PLATE
DUCT
CONNECTOR
PROTECTION
FIG.10 FIG.11
- 6 -