Programming With The Easy Configurator - Gewiss Chorus GW 10 741 Mode D'emploi

PROGRAMMING WITH THE EASY CONFIGURATOR

Programme the push-button panel module with the Easy controller (GW 90 837 / GW 90 838 / GW
90 840).
If this device is added as an expansion to a KNX system programmed with the Base Unit
(GW 90 831), please contact the Gewiss SAT Technical Assistance Service.
Each of the 6 channels to programme can be selected, as wanted:
• pressing on the channel with a brief touch: this channel will then be highlighted on
the list of channels;
• directly from the list of channels.
The channel for the temperature sensor can be selected, as wanted:
• by keeping the physical address programming push-button pressed for at least 2
seconds: this channel will then be highlighted on the list of channels;
• directly from the list of channels.
When configuring with the Easy controller, the sending of the object is disabled by default
in order to avoid the value of the temperature measured being untimely sent to the bus.
Only after the physical address programming push-button has been pressed the first
time for at least 2 seconds will the periodical transmission begin or according to the
change in the temperature.
The functions can be created once the devices have been selected.
25
E
N
G
L
I
S
H