Gewiss Chorus GW 10 741 Mode D'emploi page 22

SOUND INDICATION
The sound indication is associated only with the touch event (brief or prolonged) and if the
activation/deactivation of the glass plate cleaning function is signalled. The sound indication by touch
can be changed (reversing the current condition) with the following procedure:
• touch channels 2 and 3 simultaneously for at least 3 seconds
• a short beep will be emitted (transition from disabled to enabled), or
• or a long beep
will be emitted
The sound effect associated with the cleaning function cannot be disabled.
VARYING SENSITIVITY BY TOUCH
The touch sensor sensitivity level can be controlled (medium or high) with the following procedure:
• touch channels 1 and 5 simultaneously for at least 5 seconds: all the LEDs turn off after 3 seconds and
the blue LED of channel 3 turns on indicating the currently set sensitivity level, as per the table.
• 5°after the 5th second a short beep sounds and then medium or high sensitivity is activated (value
opposite the current one).
• the value set is indicated by channel 3 blinking with a blue light: slow blinking = medium sensitivity;
fast blinking = high sensitivity.
• when the keys are released a short beep sounds indicating that the new sensitivity value set has been
stored.
• if the keys are released before 5 seconds are up the current value is maintained (no beep).
GENERAL DESCRIPTION
(transition from enabled to disabled).
LED CHANNEL 3
Slow flashing blue
(0.5s ON, 0.5s OFF)
Quick flashing blue
(0.25s ON, 0.25s OFF)
22
SENSITIVITY
Average
High