Publicité
Les langues disponibles
Les langues disponibles
Note for installation in connection with extensions:
If you would like to install the door gate in connection with extensions, please start on page 11
and follow the instructions "Installation of Extensions".
Step 1
Place the screw casing (c) together with the adjustment screw (d) in the upper corner of the door
gate (a) across from the closure. (Ill.1)
Place the screw casing (b) together with the adjustment screw (d), (g) in the left and right lower
corners of the door gate (a). (Ill.2) , (Ill. 3)
Attention! The screw casing of the adjustment screws (b, c) do not have inner threading.
The adjustment screws are only inserted, respectively removed.
Step 2
Installation of door gate without extension
Place the door gate in the middle of the opening directly on the floor/step so that the distance
from both sides is no greater than 62 mm. (Ill. 4)
Open the function handle by pressing the 2 buttons on both sides of the handle gently and
simultaneously lifting the handle. (Ill. 5)
Pull the lower adjustment screws on both sides of the door gate out evenly until they touch the
mounting surface. (Ill.6), (Ill. 7)
Set the position of the adjustment screw using the setting wheels. (Ill. 8)
Mounting the
Step 3
When is the screw connection of the wall shells (e) absolutely necessary?
Attention!
When is the screw
• On a wooden surface -> with the included wood screws (f)
connection of the
• On plaster or soft surfaces -> with suitable screws and wall anchors
wall shells abso-
• At the top of stairs (not recommended!), with suitable screws and anchors or for installation on
lutely necessary?
wood surfaces with the included wood screws (f)
Remove the protective foil on the adhesive surface on the back of the wall shells and place these
between the adjustment screws and the mounting surface, Ill. 9 and Ill. 10.
Make the mounting easier by only turning back the adjustment screw slightly on one side of the
Tip
door gate whilst the opposite adjustment screws of the gate provide support on the mounting
surface.
(e)
wall shells
- 10 -
Publicité
