Cleaning And Maintenance - FOTILE EMG9030 Notice D'utilisation Et D'installation

6. High-speed gear button, intermediate-
speed gear button and low-speed gear button
Press , the window will display "P2", the
motor will run at an intermediate-speed gear,
the wing-like surround suction plate will go
down to the middle position.
Press again, the window will display "P3",
the motor will run at a high-speed gear, the
wing-like surround suction plate will go down to
the lowest position.
Press again, the window will display "P0",
the clock will be displayed in 3 seconds. The
motor and the wing-like surround suction plate
will be turned off.
Press again, the window will display "P1",
the motor will run at a low-speed gear, the
wing-like surround suction plate will go down to
the middle position.
Note: Every time you switch in order, the default
order will be P2-P3-P0-P1 when the motor
is turned on. Hence, the motor will start from
the previous gear state from when you turned
off the motor.
7. Automatic Function
Press , "Automatic" is displayed in the
window, and the range hood enters the
automatic cruise supercharging system.
The range hood will automatically adjust
the required airflow, wind pressure and the
position of the wing-like surround suction plate
according to the current smoke amount and
the current resistance in the exhaust pipe to
achieve the best smoke extraction effect.
Note:
1.When " " is displayed on the screen, this
indicates that the range hood has detected
large smoke extraction resistance.
2.When is displayed on the screen, this
indicates that the range hood has detected
large amounts of smoke.
3.Do not let oil stains permeate the surfaces
of the range hood for long periods of time.
4.If any saline solution, disinfectant, bleach
or other cleaners are spilled onto stainless
steel panels (most of which contain harmful
chemicals), please immediately wipe them
off with a damp cloth and then clean up with
a dry cloth.
The instantaneous reduction of odor should
meet the standard limits of IEC (61591).

CLEANING AND MAINTENANCE

Important Note:
Reattach the oil filter and wing-like plate after
cleaning and maintenance of the range hood.
Do not operate the appliance without the oil
filter and wing-like plate, as it may cause safety
hazards.
Caution:
Risk of demager due to corrosion.
• Always switch on the appliance while cooking
to avoid condensation. Condensate can
produce corrosion damage.
• Surface damage due to incorrect cleaning.
Clean stainless steel surfaces in the direction
of the grain only. Do not use any stainless
steel cleaners for operator controls.
• Surface damage due to strong or abrasive
cleaning agents.
• Replace faulty LED lights to prevent the
remaining lights form overloading.
Warning:
• The range hood should only be cleaned as
instructed; otherwise, it may ignite.
• Please remember not to wet the motor and/or
the control panel, as it may result in damaging
the electric circuits or potential hazards.
• Do not clean the appliance with chemical
- 22 -