Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Notes:
1.Reserved dimension between the cabinet and
the machine is recommended as ≥1/4 '' (5mm)
(see the figure);
2.27''-38 5/8''(685-980mm) in the cabinet match
diagram is the dimension range, including trim
cover height.
3.Installation height of the range hood is a
recommended value; the cabinet and range
hood match diagram is only for reference.
4.You may need to allow for a gap between the
upper side of the range hood and the bottom of
the cabinet to install and disassemble, please
pay attention.
Preparations before installation
Warning: To avoid damaging the range hood,
please ensure that no debris get into the air outlet.
--Estimate outlet pipe position that connects the
range hood to the outside, please refer to the
installation diagram.
--A linear and short air outlet allows the range
hood to exhaust smoke more smoothly.
--Avoid using an outlet pipe which is too long or
has too many corners since this kind of pipe will
affect the smoke exhausting effect.
--Please use duct tape to seal the connection
between the outlet pipe and the wall holes.
Please ensure a tight connection between the
outlet and the outlet housing.
--An undersized hole will affect the smoke
exhausting effect; it is recommended to broaden
the hole to 6" on the premise of ensuring safety.
6.6 Four installation requirements
1.Please firmly install the bottom of the main
machine on the wall with a height of 25 5/8''-
27 9/16'' (650-700mm) above cooker holder; if
the cooker manual stipulates a large installation
distance, this should be considered.
2.Air outlet pipe should reach outdoors, interfaces
should be sealed well;
3.In order to ensure proper smoke exhausting
effect, the exit of the outlet pipe should not be
deformed in case of decreasing supply area.
4.Power socket should be connected to the
ground grid. Power cord has a total length of
1.3m, please take this into consideration when
design the power socket position.
Warning: The waste gas from the range hood
should not be exhausted into the hot smoke
pipe that is used to exhaust smoke generated
from burning gas or other fuels.
6.7 Installation Procedures
1.Determine the space for installing the hood
above the cooktop, which shall meet the hood
installation height.
2.Use an ultrasonic stud detector to find the
wooden board behind the wall and mark it.
3.Determine the center point of the cooker and
use the horizontal ruler to draw the vertical
centerline of the range hood installation.
4.Determine the installation height of the range
hood, 25 5/8"-27 9/16" (650mm-700mm), with
a base point at the cooker holder, and draw a
baseline with a horizontal ruler.
5.Determine the position of the machine hook,
21 5/8" (548.5mm), based on the range hood
installation height line. Confirm that the trim
cover is in the position of the trim cover hook
according to the actual installation environment
(up to 15 3/4" (400mm) above the machine
hook reference line). Draw a reference line with
a horizontal ruler.
6.Unpack box and take out the machine hook and
the trim cover hook, and mark the fixing holes
for the machine hook and the trim cover hook
according to the marked position.
7.Drill holes with a diameter of 7/16'' (10 mm) and
a depth of 2 3/8'' (60 mm) at the marked points
with an impact driver. If the hole is marked over
a wooden stud, you just need to get through the
surface of the wall. Note: If there is no wooden
stud at point of the machine hook, please drill
- 31 -
Publicité
Chapitres
Table des Matières
