Application Method - FOTILE EMG9030 Notice D'utilisation Et D'installation

Application Method

Operation Interface
Calibrate the Machine and Function Description
1. Power Button
When the machine is off, press
s t a n d - b y m o d e . T h e m a c h i n e w i l l b e
automatically shut down in 2 minutes if no
further operations are started. In working/
standby mode, press
When the power button is turned on, the following
functions will be activated.
2. Cleaning Mode Button
2.1 Press , then the wing-like surround
suction plate will open at the lowest position
and enter cleaning and maintenance mode.
Press again, and the wing-like surround
suction plate returns to the highest position.
2.2 You can't choose to press the discharging
and cleaning button with
same time. If any one of the three function
buttons is turned on, pressing cleaning
button will quit the corresponding function
mode; ,
cleaning and maintenance mode.
3. Delayed Power Off Function
3.1 Clock setting: In standby mode, press
and hold to enter time setting mode;
the hour digits will begin to blink; click
to increase the hour number; if there
is no further operation, the hour digits
will stop blinking within 3 seconds; The
hour setting is completed. Then the
minute digits will begin to blink; click
to increase the minute number; if there is
no further operation, the minute digits will
to enter
to stop all functions.
, , at the
, are invalid when in
stop blinking within 3 seconds; the minute
setting is complete. The time setting is
finished.
3.2 The set time will be retained. During the
time setting, you can press any other key
to exit time setting mode.
3.3 As for the delayed power off function,
there are three modes that you can
c h o o s e f r o m . T h e c o r r e s p o n d i n g
countdown periods, respectively, are
2 minutes, 5 minutes, and 10 minutes.
Press
mode, the screen will display 02:00;
press again, it will display 05:00; then if
you press once again, it will display 10:00
and start counting down after 2 seconds.
After the delay is completed, all functions
are turned off and enter shutdown mode.
3.4 In the process of setting the delay time,
you can cancel the delayed power off
function by pressing any button.
3.5 You can forcibly shut down/turn on
the clock display in shutdown mode by
pressing and holding
mode.
4. Lighting Button
Press , the light will turn on; press again, the
light will turn off.
5. Intelligent Air Management Button
Press , the light band will blink orange. The
indictor will turn orange. The range hood will
enter intelligent air quality testing mode.
5.1 If air quality is good, the light band will be
green and the motor will not run.
5.2 If the air quality is moderate, the light
b a n d w i l l b e o ra n g e , t h e w i n g -l i k e
surround suction plate will go down to the
middle position, the motor will run at a
low-speed gear.
5.3 If the air quality is bad, the light band will
be red, the wing-like surround suction
plate will go down to the middle position,
the motor will run at an intermediate-
speed gear.
- 21 -
for the first time in the working
in shutdown