Remaining Hazards; Machine Specifications; Machine Description - Jet Tools JWBS-15 Mode D'emploi

Never leave a running machine unattended. Before you leave
the workplace switch off the machine.
Do not operate the electric tool near inflammable liquids or
gases.
Observe the fire fighting and fire alert options, for example
the fire extinguisher operation and place.
Do not use the machine in a dump environment and do not
expose it to rain.
Wood dust is explosive and can also represent a risk to
health.
Dust form some tropical woods in particular, and from
hardwoods like beach and oak, is classified as a carcinogenic
substance.
Always use a suitable dust extraction device
Before machining, remove any nails and other foreign bodies
from the workpiece.
Use a push block when working the ends of narrow stock.
Always store the push stick or the push wood handle with the
machine, also when not in use.
Specifications regarding the maximum or minimum size of the
workpiece must be observed.
Do not remove chips and workpiece parts until the machine is
at a complete standstill.
Never operate with the guards not in place – serious risk of
injury!
Do not stand on the machine.
Connection and repair work on the electrical installation may
be carried out by a qualified electrician only.
Have a damaged or worn cord replaced immediately.
Make all machine adjustments or maintenance with the
machine unplugged from the power source.
Remove defective sawblades immediately.

3.3 Remaining hazards

When using the machine according to regulations some
remaining hazards may still exist
The moving sawblade in the work area can cause injury.
Broken saw blades can cause injuries.
Thrown workpieces can lead to injury
Wood chips and sawdust can be health hazards. Be sure to
wear personal protection gear such as safety goggles ear- and
dust protection.
Use a suitable dust exhaust system.
The use of incorrect mains supply or a damaged power cord
can lead to injuries caused by electricity.

4. Machine specifications

4.1 Machine Description

1...Blade tracking window
2...Blade tension lever
3...Door catch
4...Height adjust hand wheel
5...Guide post
6...Upper blade guides
7...Mitre gauge
8...Cast iron table
9...Dust port
10...Lower wheel cover
11...Fence support rail
12...Fence
13...On/Off magnetic switch
14...Warning label
15...Blade tension window
16...Blade tension hand wheel
17...Upper wheel cover
18...Lifting ring
Fig 1