Husqvarna HTC 5 Manuel De L'opérateur page 34

HTC T5
Slide the new grinding tool diagonally, from
above, down into the appropriate guide slot
on the tool holder. Then push the tool fully
into the guide slot.
Lock the grinding tool into the tool holder by
giving it a few light taps with a hammer.
When changing the grinding tool, loosen it
by giving it a few light taps with a hammer so
the locking mechanism releases. Then draw
the tool up out of the guide slot.
36
NOTE
Let the dust extractor run while changing tools.
NOTE
Note the direction of rotation of the grinding discs.
Operation
D004753, 01.01