Dnis; Account Code; Enable Supervision; Supervision Time - Bentel Security BGSM-100 Mode D'emploi

DNIS

If required, enter the Dialled Number Identification Service number.

Account code

An account code is required for communication with Sur-Gard SYSTEM III or SYSTEM II receivers. Enter the Account Code
in this field.

Enable Supervision

To enable supervision, select this option. The supervision option is ONLY available to the primary receiver.

Supervision time

Set the Supervision time for the monitored zones. It is possible to set a Supervision time between a minimum of 1 second
and a maximum of 65535 seconds, with steps of 1 second.

Status

This page will allow you to monitor and control in real-time all the Communicator functions.
, , , , , ATTENTION: This page is updated every 5 seconds.

Status section

This section lists the most important data relating to the GSM module. The virtual display shows, in addition to the name of
the GSM network manager, the GSM signal strength (this is displayed through a special indicator).
The Device status indicator may be ON or OFF .The Device status indicator light when it is GREEN: proper function. When
it is RED, this indicates that there is no communication between the software and the device; if it is AMBER it means that
details of the Device status are being acquired.
BGSM-100
G G G G G
29