Bosch Professional GCM 10 SD Notice Originale page 41

Technical Data
Sliding Mitre Saw
Article number 0 601 B22 ...
Rated power input
No-load speed
Weight according to EPTA-Procedure 01/2003
Protection class
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Mounting hole diameter
Permissible workpiece dimensions (maximal/minimal) see page 47.
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries,
these values can vary.
Starting cycles generate brief voltage drops. Interference with other equipment/machines may occur in case of un-
favourable mains system conditions. Malfunctions are not to be expected for system impedances below 0.15 ohm.
Please observe the article number on the type plate of your machine. The trade names of the individual machines
may vary.
Noise/Vibration Information
Measured sound values determined according
to EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 94 dB(A);
Sound power level 104 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 61029:
Vibration emission value a
2
tainty K =1.5 m/s .
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 61029 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
Bosch Power Tools
2
=3.0 m/s , Uncer-
h
... 503
... 508
... 532
... 542
W 1800
-1
min 5000
kg 27
/II
mm 254
mm 2.0
mm 30
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
English | 41
GCM 10 SD Professional
... 537 ... 541
1800
5000
27
/II
254
2.0
25.4
1 609 929 X04 | (13/7/10)
1450
4500
27
/II
254
2.0
30