Publicité
Les langues disponibles
Les langues disponibles
Inserting and Removing a Bit
(fi g. 2)
1. Align the pilot hole (f) in the chuck (b) with an
opening in the chuck guard (c).
2. Insert the chuck key into the pilot hole (f).
3. Open the chuck jaws (g) by turning
counterclockwise.
4. Insert the shank of a bit into the chuck.
5. Tighten the chuck using all three holes.
To remove the bit, proceed in reverse order.
Chuck Key Holder (fi g. 3)
Fit the chuck key (e) to the chuck key holder (d) as
shown.
Chuck Removal (fi g. 4)
1. Tighten a hex wrench into the chuck (b) and
strike it with a hammer as shown.
2. Unscrew the chuck by hand.
Prior to Operation
1. Insert the appropriate bit.
2. Mark the spot where the hole is to be drilled.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Proper Hand Position (fi g. 5)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
The drill can be used in various positions as shown
in figure 5, for optimum control.
Switching On and Off (fi g. 1)
To run the tool, press the paddle switch (a). The
pressure exerted on the paddle switch determines
the tool speed. To stop the tool, release the paddle
switch.
To stop the tool, release the paddle switch.
Drilling
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: To reduce the risk of
personal injury, ALWAYS ensure
workpiece is anchored or clamped
firmly. If drilling thin material, use a wood
"back-up" block to prevent damage to
the material.
1. Use sharp drill bits only. For WOOD, use the
low speed setting and twist drill bits, spade bits,
power auger bits, or hole saws. For METAL, use
the low speed setting and steel twist drill bits or
hole saws.
2. Always apply pressure in a straight line with the
bit. Use enough pressure to keep drill biting, but
do not push hard enough to stall the motor or
deflect the bit.
3. Hold tool firmly with both hands to control the
twisting action of the drill.
CAUTION: Drill may stall if overloaded
causing a sudden twist. Always expect
the stall. Grip the drill firmly to control
the twisting action and avoid injury.
4. IF DRILL STALLS, it is usually because
it is being overloaded or improperly used.
RELEASE TRIGGER IMMEDIATELY, remove
drill bit from work, and determine cause of
stalling. DO NOT CLICK TRIGGER ON
AND OFF IN AN ATTEMPT TO START A
STALLED DRILL — THIS CAN DAMAGE
THE DRILL.
5. To minimize stalling or breaking through the
material, reduce pressure on drill and ease the
bit through the last fractional part of the hole.
6. Keep the motor running when pulling the bit
back out of a drilled hole. This will help prevent
jamming.
7. With variable speed drills there is no need to
center punch the point to be drilled. Use a
slow speed to start the hole and accelerate by
squeezing the trigger harder when the hole is
deep enough to drill without the bit skipping out.
EN GL IS H
23
Publicité
