Télécharger Imprimer la page

DETAIL K2 MMT4X6O Guide D'assemblage page 5

Publicité

Les langues disponibles

Les langues disponibles

STEP 4
Place the Axle on the top pf the Spring. Align depression on Axle with protrusions on
Spring.
On each end of the Axle, place Spring Plates under Spring and insert M12 x 90 U-bolt
downward over the Axle and through the mounting hole in the Spring Plate. Adjust the
Spring Plates slightly to allow the holes to line up.
Secure the Axle with M12 washers and M12 Nylock nuts.
NOTE:
Insert the raised point on the spring into the concave on the axle.
Make sure that the axle is in the right position.
En.a5
v.191129

Publicité

loading