Télécharger Imprimer la page

DETAIL K2 MMT4X6O Guide D'assemblage page 4

Publicité

Les langues disponibles

Les langues disponibles

STEP 3
Insert the two M14 x 95 mm bolts from inside through the springs, nuts, washers and
fender L-brackets, then tighten just until spring is secure. Do not over-tighten, since the
brackets will need adjustment to the fenders later and it may collapse spring channel.
Place the tongue tube between the two drawbar reinforcment brackets by using M14 x
85 mm bolts.
Install the coupler and safety chains using the M10 x 80 mm bolts and M10 lock nuts
provided.
The front bolt passes though the end link of the safety chain as it is inserted through
the tongue tubes. Tighten both bolts.
En.a4
MMT4X6O man

Publicité

loading