Hoover TurboPOWER WindTunnel Mode D'emploi page 4

1-5
Place nuts in recessed areas on
front of handle. Hold each nut in
place while tightening each bolt
securely with a Phillips screw driver.
STEP II Attach hose
1-8
A
B
Align end of hose with projections
(A) over slots (B) in dirt duct.
STEP III Position tools
1-11
Place smaller unridged end of wand
into bottom of rack. Snap wand into
clip. Repeat with other wand.
4
1-6
Reposition bag door by fitting tabs
on bottom of door into opening.
Press top of door to snap securely
shut.
NOTE: Hose must be connected as shown for all
operations.
1-9
B
Slide hose into (B) and twist hose to
lock it into place.
1-12
A
B
Position dusting brush (A) and furni-
ture nozzle (B) into areas as shown.
Place crevice wand (C) inside exten-
sion wand.
1-7
Position cord on back of cleaner as
shown and press cord into clip.
1-10
Lift hose tube cover (C).
Position hose over hose hook (D)
and into hose tube (E).
C
C
D
E