Sony DS-HMD1 Mode D'emploi page 26

Symptom
The progress bar
in the display does
not move during
the SonicStage
installation. The
access lamp on the
CD drive or hard
disk drive has not
lit up for a few
minutes.
The drive has not
been correctly
recognized as a
removable disc.
Data cannot be
saved to the disc
in the drive.
26
-GB
Cause/Remedy
• The installation is progressing normally.
, Please wait.
The installation may take 30 minutes or more,
depending on your CD drive or system
environment.
• The drive does not contain a disc in Hi-MD mode.
, You cannot write data to a disc that contains
material recorded in MD mode. Replace the disc
with one in Hi-MD mode, or format the disc in
Hi-MD mode using the supplied SonicStage.
• SonicStage is active.
, The computer will not recognize the drive as an
external device if SonicStage is active. Close
SonicStage.
• The USB cable is not connected firmly.
, Connect the USB cable firmly.
• The computer was restarted while the drive was still
connected.
, Reconnect the drive to the computer.
• The connections are made through a USB hub.
, Operations are not guaranteed for USB hub
connections. Use the supplied USB cable to
connect the drive directly to the USB port on the
computer.
• You are using a computer on which the supplied
SonicStage or the driver for this drive has not been
installed.
, Install SonicStage or the driver from the supplied
CD-ROM.
• There is insufficient free space on the disc in the drive.
, Replace the disc with one with sufficient free
space.
• You tried to store data to a disc with the tab in the
record-protect position.
, Slide the tab back (page 23).