Sony DS-HMD1 Mode D'emploi page 11

Before installing SonicStage
• Close all the Windows software programs. Especially, make sure to
close any virus-check software, as such software usually demands a
large amount of system resources.
To use this drive, you must install SonicStage from the supplied CD-
•
ROM.
— If OpenMG Jukebox or SonicStage is installed already, the current
software will be overwritten by the new version. The new version
retains the functions of the older version, but with new functions
added.
— If SonicStage Premium is installed already, the current software will
co-exist with the new version.
— You will still be able to use music data registered by the older
software version even after the new SonicStage has been installed.
As a precaution, we recommend that you back up your music data.
To back up the data, refer to [Backing Up My Library] on
SonicStage Help.
• Make sure to install SonicStage before connecting the drive to the
computer with the supplied USB cable.
1
Turn on your computer and start up Windows.
2
Insert the supplied CD-ROM into the CD drive
of your computer.
The setup program starts up automatically.
3
When the [Region Selection] screen appears,
select the region where the SonicStage
software will be used, and then click [Next].
4
Click [Install SonicStage] and then follow the
displayed instructions.
Read the instructions carefully.
The installation may take 20 to 30 minutes, depending on your
system environment.
Make sure to restart your computer only after the installation is
completed.
11
-GB